Visonic PowerMax10 Especificações descarregar pdf (Página 7)

6 D-302756

A. Network Service Provider's Facilities

B. Telephone Line

C. Network Demarcation Point

D. RJ-31X Jack

E. Telephone

F. Alarm Dialing Equipment

G. Answering System

H. Unused RJ-11 Jack

I. Fax Machine

J. Computer

Note: The REN is used to determine the number of devices

that may be connected to a telephone line. Excessive RENs

on a telephone line may result in the devices not ringing in

response to an incoming call. In most but not all areas, the

sum of RENs should not exceed five (5.0). To be certain of

the number of devices that may be connected to a line, as

determined by the total RENs, contact the local telephone

company.

Connection to telephone company provided coin service is

prohibited. Connection to party lines service is subject to

state tariffs.

3.2 System Planning &

Programming

It pays to plan ahead - use the tables in appendices A and

B at the end of this guide to register the intended location

of each detector, the holder and assignment of each

transmitter.

Gather up all transmitters and detectors used in the

system and mark each one in accordance with your

deployment plan.

Program the system now, before mounting, as

instructed in the programming section.

3.3 Mounting the Unit

Required tool: Philips screwdriver #2.

PowerMax10-G2 mounting process is shown in Figure 3.3

- 3.4.

A. Mounting surface

B. Back unit

To Mount the Unit:

1. Release the screws

2. Remove the front cover

3. Mark 4 drilling points on the mounting surface

4. Drill 4 holes and insert wall anchors

5. Fasten the back unit with 4 screws

Figure 3.3 – Back Unit Mounting

1 2 3 4 5 6 7 8 9 10 11 12 ... 77 78

Comentários a estes Manuais

Sem comentários

Visonic PowerMax10 Especificações Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Visonic PowerMax10