Visonic PowerMax10 Especificações descarregar pdf (Página 43)

42 D-302756

The PowerMax10-G2 display will revert to [33:CONFIRM TIME].

OKI

You can now press the or button to program any other menu in

DEFINE PANEL

" or press the button to take you to "

<OK> TO EXIT

4.7.8 Enable Alarm upon Detection of Jammed or Missing Device

Here you determine whether an alarm will be initiated (siren / report) when there is a supervision / jamming failure during

AWAY arming state.

Available options are: EN standard and other (default). When "EN standard" is selected, if there is supervision /

jamming failure during AWAY arming, the siren is activated and the events are reported as tamper events. When "Other"

is selected, there is no such activity during AWAY arming.

To Enable an Alarm Upon Detection of a Jammed or Missing Device

1. Make sure the system is disarmed and then press the button

repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".

When the PowerMax10-G2 display reads [INSTALLER MODE], press

OKI

The screen will now prompt you to enter your installer code.

OKI

Enter your Installer Code.

CODE

4. Press the or button repeatedly and select the [DEFINE PANEL]

option.

5. When the PowerMax10-G2 display reads [DEFINE PANEL], press

OKI

The PowerMax10-G2 display will read [01:ENTRY DELAY 1].

OKI

When the PowerMax10-G2 display reads [01:ENTRY DELAY 1], press

the

or button repeatedly until the display will read

[30:BELL/REP.OPT].

Press

OKI

and make the selection and then press

OKI

to confirm.

The PowerMax10-G2 display will revert to [30:BELL/REP.OPT].

OKI

SELECT OPTION

OKI

You can now press the or button to program any other menu in

DEFINE PANEL

" or press the button to take you to "

<OK> TO EXIT

4.7.9 Configuring the Jamming Detection

Here you determine whether jamming (interfering transmissions, on the radio channel used by the system) will be detected

and reported or not.

If a jam detection option is selected, the system does not allow arming under the relevant jamming conditions.

Jam Detection Options

Option Detection and Reporting when

UL 20/20

(USA standard)

There is continuous 20 seconds of

jamming

EN 30/60

(Europe standard)

There is an accumulated 30 seconds of

jamming within 60 sec.

class 6 (30/60)

(British standard)

Like EN (30/60) but the event will be

reported only if the jamming duration

exceeds 5 minutes.

Disable (default) (No jamming detection and reporting).

0:BELL/REP.OPT

3:CONFIRM TIME

ELL/REP.OPT

1:ENTRY DELAY 1

NTER CODE: 

INSTALLER MODE

EADY 00:00

EFINE PANEL

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 77 78

Comentários a estes Manuais

Sem comentários

Visonic PowerMax10 Especificações Página 43

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Visonic PowerMax10