Visonic PowerMax10 Especificações descarregar pdf (Página 69)

68 D-302756

7. MAINTENANCE

7.1 Handling System Troubles

Fault What it means Solution

The control panel cannot configure or control

the device.

Battery consumption increases.

i) Make sure the device is physically present.

ii) Check the display for device faults, for

example, low battery.

iii) Use RF diagnostics to check the current

signal strength and during the last 24 hours.

iv) Open the device cover and replace the

battery or press the tamper switch.

v) Install the device in a different location.

vi) Replace the device.

A device was not installed or not installed

correctly, or, cannot establish communication

with the control panel after installation.

i) Make sure the device is physically present.

ii) Use RF diagnostics to check the current

signal strength and during the last 24 hours.

iii) Open the device cover and replace the

battery or press the tamper switch.

iv) Enroll the device again.

A device or detector has not reported for some

time to the control panel.

i) Make sure the device is physically present.

ii) Check the display for device faults, for

example, low battery.

iii) Use RF diagnostics to check the current

signal strength and during the last 24 hours.

iv) Replace the battery.

v) Replace the device.

A radio-frequency signal which is blocking

communication channel of sensors and control

panel is detected.

Locate the source of interference by switching

off any wireless devices (cordless telephones,

wireless ear plugs, etc.) in the house for 2

minutes then check if trouble continues.

Use also RF diagnostics to check signal

strength.

The battery in a sensor, keyfob or wireless

commander is near the end of its useful life.

i) For AC powered devices, check AC power is

available and connected to the device.

ii) Replace the device battery.

The fire detector must be cleaned Use a vacuum cleaner to clean the detector air

vents occasionally to keep them free of dust.

Gas detector failure Gas detector: Disconnect and then put back

the AC power supply connector

CO Gas detector: Replace the detector

There is no power to the siren Make sure that the AC power supply is

connected properly

There is no power to gas sensor Make sure that the AC power supply is

connected properly

The GSM communicator is not able to connect

to the cellular network.

i) Move the Panel and GSM unit to another

location.

ii) Enter and exit the installer menu

iii) Disconnect GSM unit and install it again

iv) Replace SIM card

v) Replace the GSM unit

The GSM communicator has detected that GSM

network signal is weak

Move the Panel and GSM unit to another

location.

There is no power and the system is working on

backup battery power

Make sure that the AC power supply is

connected properly

C SUPPLY FAILURE

SSI LOW

SM NET FAIL

C FAILURE

IREN AC FAILURE

AS TROUBLE

LEAN ME

OW BATTERY

AMMING

ISSING

OT NETWORKED

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 77 78

Comentários a estes Manuais

Sem comentários

Visonic PowerMax10 Especificações Página 69

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Visonic PowerMax10