Visonic POWERMASTER-10 Guia do Utilizador descarregar pdf (Página 23)

REVIEWING TROUBLES AND ALARM MEMORY

22 D-303223 PowerMaster-10 / PowerMaster-30 User's Guide

5. Reviewing Troubles and Alarm memory

Alarm & Tamper Memory Indication

The PowerMaster-10 / PowerMaster-30 retains in its memory alarm and “tamper” events that occurred during

the last arming period.

Note: Alarm events are memorized only after the “abort period” (see Appendix B). This means that if you disarm

the system immediately - before the abort period expires - there will be no memory indication

A. Indication of Alarm & Tamper Condition

If the system is disarmed following an alarm event, a flashing MEMORY message will be displayed, as follows:

READY HH:MM

(alternating)

READY MEMORY

B. Displaying Alarm & Tamper Information

To review memory content, click button.

EXAMPLE: An alarm was triggered because the garage door - zone No. 12 – was opened but then closed. In

addition, the bedroom motion detector - zone No. 7 - sent a “Tamper” message because its cover had been

removed.

PRESS RESULTING DISPLAY

POWERMASTER-10

∗

Z12 ALARMED

(alternating)

Z03 CONTACT

(alternating)

GARAGE DOOR

Z07 TAMPER-OPEN

(alternating)

Z06 MOTION SENS

(alternating)

BEDROOM

↓

READY HH:MM

In response to additional clicking of the button, the display shows details of other events retained in

open tamper (if any), or reverts to its initial state (see A above).

If the system is NOT READY, the display will first read the open zones and then alarm memory events.

∗

When working from the PowerMaster-30 control panel, the display will read "PowerMaster-30"

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Sem comentários

Visonic POWERMASTER-10 Guia do Utilizador Página 23