Visonic POWERMASTER-10 Guia do Utilizador descarregar pdf (Página 12)

OPERATING THE POWERMASTER SYSTEM

D-303223 PowerMaster-10 / PowerMaster-30 User's Guide 11

ENTER CODE

_ _ _ _

Arming ‘AWAY’

If the system is READY and quick arming is allowed, proceed as shown:

PRESS RESULTING DISPLAY

ARMING AWAY

PLEASE EXIT NOW

Vacate the premises

↓ (Exit delay) ↓

AWAY

ARM indicator lights steadily during the armed state.

Arming ‘HOME'

If all perimeter zones are READY, and quick arming is allowed, proceed as shown:

PRESS RESULTING DISPLAY

ARMING HOME

Move to interior zone

↓ (Exit delay) ↓

AWAY HH:MM

ARM indicator flashes during the armed state.

Disarming and Stopping Alarm

Enter the protected premises via a delayed zone. Upon detecting your entrance, the system will start sounding

the entry delay beeps alerting you to disarm the system before the entry delay ends. To disarm the system

proceeds as shown:

PRESS RESULTING DISPLAY

CODE _ _ _ _

[Enter Code] Code

READY HH:MM

ARM indicator extinguishes during the disarmed state.

Disarming the system also stops the siren alarm, irrespective of whether the alarm was initiated during the

armed or the disarmed state.

Disarming after an Alarm or Trouble

After disarming, different displays may appear indicating that the system is in a state of TROUBLE (TRBL) or

alarm MEMORY and will also sound trouble beeps once per minute. To find out the troubles that have

been detected, or which zone alarmed, see Chapter 5. Reviewing Troubles and Alarm memory.

Upon eliminating the cause for trouble the TRBL display will disappear, the TROUBLE indicator will extinguish

and the trouble beeps will stop.

The MEMORY message will disappear only upon rearming the system.

IMPORTANT! If the trouble beeps bother you, disarm the system again (even though it is already disarmed).

This will cancel the trouble beeps for 4 hours.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

Sem comentários

Visonic POWERMASTER-10 Guia do Utilizador Página 12