Visonic POWERMASTER-10 Guia do Utilizador descarregar pdf (Página 16)

OPERATING THE POWERMASTER SYSTEM

D-303223 PowerMaster-10 / PowerMaster-30 User's Guide 15

Initiating Alarms

Following are various methods that may be used for initiating alarms.

Initiating Panic Alarm with Keyfobs

Using the KF-234 PG2 you can initiate a PANIC alarm by pressing both AWAY

and HOME keys

simultaneously for 2 seconds.

Low Battery Indication

If the battery power is near the end of its life, the keyfob LED indicates this by flashing the yellow light at the end

of keyfob activation. It will also send a "low battery" signal to the panel which will be indicated on the LCD

display as a trouble message (see Chapter 5. Reviewing Troubles and Alarm memory). When "low battery"

occurs, you must replace the battery within 2-3 weeks otherwise your keyfob will stop functioning.

Acknowledging “low battery” condition

Some regulations and institutions require the user to acknowledge when the keyfob enters the “low battery”

condition. The acknowledge procedure is described in Chapter 6.

Initiating Panic Alarm

You can generate a panic alarm manually in the disarmed and armed states alike. The sequence will be as

shown:

PRESS RESULTING DISPLAY

PANIC ALARM

simultaneously

READY HH:MM

To stop the alarm, press the

button

and then key in your valid user code.

Initiating Fire Alarm

(This function is disabled in ACPO compliant version).

You can generate a fire alarm in disarmed & armed states, as follows:

PRESS RESULTING DISPLAY

FIRE ALARM

for 2 seconds

Then, if or when the

system is in the disarmed

READY HH:MM

(alternating)

READY MEMORY

To stop the alarm, press and then key in your valid user code.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Sem comentários

Visonic POWERMASTER-10 Guia do Utilizador Página 16