Visonic POWERMASTER-10 Guia do Utilizador descarregar pdf (Página 53)

EVENT REPORTING & CONTROL BY TELEPHONE AND SMS

52 D-303223 PowerMaster-10 / PowerMaster-30 User's Guide

7. Event Reporting and Control by Telephone and SMS

Event notifications by Telephone

The PowerMaster-10 / PowerMaster-30 can be programmed for selective notification of event messages to

private telephone subscribers – See Chapter – 6, C.11 Programming Private Phone and SMS Reporting.

In case of alarm the following voice signal will be sent to private telephones upon event reporting:

* FIRE: ON - ON - ON - pause.... (- - - - - - ......).

** BURGLAR: ON continuously (

...)

*** EMERGENCY: 2-tone siren; like an ambulance.

To stop the alarm notification – press the "2" key on your telephone keyboard. The alarm sound will stop

immediately.

The called party must acknowledge the message (as explained later on). However, if there is no response the

message will be repeated as many times as possible within a 45-second time limit. When the 45 seconds are

up, the PowerMaster-10 / PowerMaster-30 will disengage the line and call the next private telephone number on

its list.

The called party must acknowledge the message by pressing the "2" key on the telephone keypad. As a result,

the PowerMaster-10 / PowerMaster-30 may continue to notify the next programmed telephone number, or if so

programmed, consider the event as reported - See Chapter – 4C.10.

Event notifications by SMS

The PowerMaster-10 / PowerMaster-30 system when equipped with a GSM unit can be programmed to send

SMS event notification messages to 4 pre-selected telephone numbers - See Chapter – 4C.10. The messages

can be tagged with a "House ID" name, for example, "JOHN'S HOME", see Remote Control by SMS section,

command no. 9.

Example of the reported SMS messages:

• JOHN’S HOME

**AWAY**

• JOHN’S HOME

**DISARM**

• JOHN’S HOUSE

POWERMASTER-10 / POWERMASTER-30: LOW BATTERY

GARAGE: LOW BATTERY

• JOHN’S HOUSE

STATUS MESSAGE 01

(Event list is displayed)

Note: Status messages can be sent only to a calling telephone whose identity number is not blocked by the

user!

Remote Control by Telephone

The PowerMaster-10 / PowerMaster-30 allows you to initiate calls from your private telephone to the

PowerMaster-10 / PowerMaster-30 control panel via PSTN (landline) or GSM and to perform a variety of arming

commands remotely using your telephone's keypad.

To connect to the PowerMaster-10 / PowerMaster-30 via PSTN:

1. Dial the PowerMaster-10 / PowerMaster-30 PSTN tel. No.

2. Wait for 2-4 rings then hang up.

3. Wait 12-30 sec.

4. Redial PowerMaster-10 / PowerMaster-30 tel. No. (Sound will be heard for 10 sec.).

[*] (to stop the sound)

6. [User code], [#]

7. [Desired command, see next table]

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 75 76

Comentários a estes Manuais

Sem comentários

Visonic POWERMASTER-10 Guia do Utilizador Página 53

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Visonic POWERMASTER-10