Visonic PowerMax10 Especificações descarregar pdf (Página 8)

8 DE5450 PowerMax Installation Instructions

5.3 Fuse Replacement

The PowerMax has a fuse which can burn out:

Siren Fuse - 0.5 A, time delay type, per IEC127-3 (in

Europe).

If the siren fuse burns out, the trouble indicator lights and

TRBL is displayed (together with READY or NOT READY -

as the case may be). Clicking the <SHOW /OK> button will

display a FUSE TROUBLE message.

The fuse is accessible through the rectangular opening at

the rear of the cabinet (see figure 2). To replace the fuse,

the cabinet should be temporarily dismounted (as shown in

figure 3).

Extract the suspected fuse and check it visually. In most

cases, a defective fuse can be identified by the broken

conductor within the glass cylinder. If in doubt, test the

continuity of the fuse with an ohmmeter.

Replace a defective fuse with a new one of the same

ratings. The relevant trouble indications will immediately

disappear.

5.4 Replacing/Relocating Detectors

Whenever the maintenance work involves replacement or

re-location of detectors, you must keep in mind that It is

mandatory to perform a full diagnostic test per Section

9 of the Programming Guide.

Remember! A "poor" signal is not acceptable, as stated at

the end of the test procedure.

APPENDIX A. Detector Deployment & Transmitter Assignments

APPENDIX A. Detector Deployment & Transmitter AssignmentsAPPENDIX A. Detector Deployment & Transmitter Assignments

APPENDIX A. Detector Deployment & Transmitter Assignments

A1. Detector Deployment Plan

Zone

No.

Zone Type Sensor Location or Transmitter Assignment

(in non-alarm or emergency zones)

Chime

(Yes / No)

Controls PGM

(X = YES)

Controls

X-10 Unit No.

Zone Types: 1 = Interior



2 = Perimeter



3 = Delay 1



4 = Delay 2



5 = 24 h silent



6 = 24 h audible



7 = Fire



8 = Non-alarm



9 = Emergency.

Zone Locations: Note down the intended location for each detector. When programming, you may select one of 26

available zone names (plus 3 custom zone names that you can add - see Figure 3 in the Programming Guide).

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

Visonic PowerMax10 Especificações Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Visonic PowerMax10