Visonic POWERMASTER-10 - INSTALLER GUIDE Especificações descarregar pdf (Página 25)

4. POWERMASTER-30 G2 INSTALLATION

24 D-303222 PowerMaster-10/30 G2 Installer's Guide

The 12V and "GND" terminals can be connected to a siren (for constant DC power supply).

*** The.12V supply to the PGM device is fused. Current is limited to 100 mA.

WARNING! When plugging terminals back into place, be sure to align them carefully with the pins on the PCB.

Misaligned or reverse insertion of terminals may damage internal PowerMaster-30 G2 circuits!

IMPORTANT! The terminals for internal and external sirens are DC outputs intended for 12V sirens. Connecting a

loudspeaker to any of these outputs will cause a short circuit and will damage the unit.

4.10 Connecting Power to the Control Panel

Note: Do not use mains cable (3 m long) or power supply other than that supplied by the manufacturer LEADER

ELECTRONICS, model no. MU24-11125-A10F. For UL installations (UL), the plug-in transformer must have restraining

means. For Canada (CUL), it cannot have restraining means.

Note: This equipment should be installed in accordance with Chapter 2 of the National Fire Alarm Code, ANSI/NFPA 72 and

CAN/ULC-S540.

Notes for UL installations:

1. A device that is connected to PGM terminal should not be programmed to be activated during standby.

2. The system shall be installed in accordance with CSAC22.1 Canadian Electrical Code, Part 1.

3. A minimum spacing of 1/4 inch shall be maintained between the telephone wiring and the low voltage wiring (zones,

bell circuit, etc.) Do not route the LINE and SET wires in the same wiring channel with other wires.

4. Do not connect to a receptacle controlled by a switch.

5. Hard wired zones are for BURG use only.

Connect the power cable and close the control panel as shown in Figures 4.10a – 4.10b.

POWER CONNECTION FOR INTERNAL POWER SUPPLY

Perform steps 1 & 2 on a workbench before mounting.

1. Thick cable entry: Pull out a desired wiring plastic

cap (1 of 4).

2. Extract cable clamp (I) for use in the next step

3. Insert the power cable through the desired wiring

channel (A). Route it to the power supply unit (E) and

remove the safety cover (D). Connect the 2 wires of

the power cable to the power supply terminal block

(F) with a screwdriver. Fasten the screws tightly.

Fasten the power cable by its clamp (B or C) and

close the safety cover (D).

4. Connect the power supply output cable (G) to the

power connector (H) in the front panel.

A. Optional wiring channels

B. For thin cable

C. For thick cable (reversed clamp)

D. Safety cover

E. Power supply unit

F. Power supply terminal block

G. Power supply output cable

H. Power connector

(*) Do not route wiring in this area, to enable proper

closure of the control panel.

I. Cable clamp.

Figure 4.10a – Power Connection For Internal Power Supply

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 81 82

Comentários a estes Manuais

Sem comentários

Visonic POWERMASTER-10 - INSTALLER GUIDE Especificações Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Visonic POWERMASTER-10 - INSTALLER GUIDE