Visonic POWERMASTER-10 - INSTALLER GUIDE Especificações descarregar pdf (Página 55)

54 D-302756

Select between "enable beeps", "off when home" and "disable

beeps".

You can now press the or button to program any other

menu in "

DEFINE PANEL

" or press the button to take you to "

<OK>

TO EXIT

4.10.3 Enabling the Back Light

Here you determine whether the keypad back lighting will remain on at all times or will turn on when a key is

pressed and turn off within 10 seconds if no further keystrokes are sensed.

The two options are: always ON and OFF after 10 s (default).

To Enable the Back Light

Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".

Select between "OFF after 10s", and "always ON".

You can now press the or button to program any other

menu in "

DEFINE PANEL

" or press the button to take you to "

<OK>

TO EXIT

4.10.4 Configuring the Disarm Option

Here you determine when it is possible to disarm the system:

A. Any time.

B. In AWAY mode, during entry delay, by using the PowerMaster-10 keypad or wireless sensor (keyfob).

C. In AWAY mode, during entry delay, by using a wireless device (keyfob) only (this is set as a default in UK to

comply with DD243).

D. During entry delay, or by using the PowerMaster-10 keypad in AWAY mode.

Options: any time (default), on entry wireless, entry + away kp (default in UK), or on entry all.

To Configure the Disarm Option

Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".

DEFINE PANEL

22:BACK LIGHT

OFF after 10s



22:BACK LIGHT

01:ENTRY DELAY 1

DEFINE PANEL

10:PIEZO BEEPS

enable beeps



1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 85 86

Sem comentários

Visonic POWERMASTER-10 - INSTALLER GUIDE Especificações Página 55